10. Removing Tilt belt (Synchro belt (N180)) and Syncro pulley (N132)
10-1. Remove Screws 107 (x4), then remove Camera base 11 and Camera cover 5 .
This is the disassembling procedure after the disassembling of:
1. Removing Base unit: Page 9
2. Removing Rotation unit: Page 9
3. Removing Main board ass'y: Page 10
4. Removing Power board ass'y: Page 11
5. Removing Camera unit and Fan motor ass'y: Page 12
10-2. Remove Tilt belt (Synchro belt (N180)) 54 while turning.
10-3. Remove Screws 106 (x2), then remove Synhcro pulley (N132) 20 .
Refer to Step 5-2 through Step 5-4 on page 26, 6-1 on page 27 and page 31 through page 34 for reassembling.
107
Figure of Step 10-1
54
Tilt belt (Synchro belt (N180))
Figure of Steps 10-2 and 10-3
5
Camera cover
11
Camera base
Screws
3x8mm (x4)
107
106
Screws
2.6x6 mm (x2)
20
Synchro pulley (N132)
–17–