HP 12500 Series Installation Manual page 61

Board SlotNo...
Subcard exist testing...
DX246 testing...
PHY88E1111 testing...
CPLD1 testing...
CPLD2 testing...
NS16550 register testing...
The default switch's Mac address...
CF Card testing...
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
When the POST is completed, the switch boots the applications. The following information appears on
the terminal screen (only part of the display information is given in this example):
Starting to get the main application file--flash:/switch.bin!
The main application file is self-decompressing.............................
..........................................................................
..........................................................................
..........................................................................
..........................................................................
..........................................................................
..........................................................................
Done!
System is starting...
Starting application at 0x00100000 ...
TLB init OK.
LBC init OK.
LAW init OK.
Bsp init start...
MMU init OK.
CRC init OK.
Frame data init OK.
Connect IRQ 0 OK.
Enable IRQ 0 OK.
Connect IRQ 1 OK.
Enable IRQ 1 OK.
Connect IRQ 2 OK.
Enable IRQ 2 OK.
Connect IRQ 4 OK.
Enable IRQ 4 OK.
Connect IRQ 5 OK.
Enable IRQ 5 OK.
Connect IRQ 6 OK.
After the switch completes booting the applications, the following information appears on the terminal
screen:
Press ENTER to get started.
Press Enter to begin configuring the switch at the prompt:
<HP>
[ 1
[ PASS ]
[ PASS ]
[ PASS ]
[ PASS ]
[ PASS ]
[ PASS ]
[00:0F:11:11:10:00]
[ PASS ]
55
]