Driveplate Kit
Reelmaster
Traction Unit with Yanmar Engine
Model No. 138-6973
Use of this product may cause exposure to chemicals known to the State of California
to cause cancer, birth defects, or other reproductive harm.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
No parts required
No parts required
Flywheel-adapter plate
Backup plate
Capscrew (3/8 x 1 inch)
Flange locknut (3/8 inch)
Flange-head capscrew
Backup ring
No parts required
No parts required
Preparing the Machine
CAUTION
If you leave the key in the switch, someone
could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the switch before you
perform any maintenance.
1.
Park the machine on a level surface, engage
the parking brake, lower the cutting units, shut
off the engine, remove the key, and wait for all
movement to stop before leaving the operator's
seat.
2.
Unlatch and tip the operator's seat.
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
5410/5510/5610-D or Groundsmaster
WARNING
CALIFORNIA
Proposition 65 Warning
Qty.
–
Prepare the machine.
–
Remove the hood saddle and drive-line guard.
–
Remove the driveshaft and flywheel-adapter plate.
1
1
Replace the flywheel-adapter plate.
6
6
8
Install the driveshaft and flywheel-adapter plate.
2
–
Install the drive-line guard and hood saddle.
–
Finish the kit installation.
Removing the Hood Saddle
and Drive-Line Guard
Register at www.Toro.com.
3.
Unlatch and open the hood.
1.
Lift the hood saddle from the saddle brackets,
and remove hood saddle from the machine
(Figure
1).
Original Instructions (EN)
All Rights Reserved *3425-668* A
Printed in the USA
Form No. 3425-668 Rev A
®
4300-D Series
Installation Instructions
Use