Siemens IFP1900 INOX PRO Compact Operating Instructions page 14

Installing the device
3.2 Mounting and connecting the device
Procedure
1. Open the connection compartment. To do so, remove the 6 screws on the device rear
that are marked in the following figure and remove the connection compartment cover
and associated seal.
2. Place the supplied seal for the mechanical interface with its smooth side onto the stand.
Center the openings of the seal and of the mechanical interface of the stand.
3. Route the lines from the stand through the opening of the mechanical interface of the
device into the connection compartment.
4. Place the mechanical interface of the device onto the mechanical interface of the stand.
Take the following into account:
– The seal has to lie exactly in the mechanical interface of the device.
– The lines must not be squeezed. Hold the lines slightly tensioned while placing the
5. Fasten the device to the mechanical interface of the stand using the four M5 screws.
Insert the screws from below through the mechanical interface and tighten the screws
with a torque of 3.5 Nm. The degree of protection IP66 is only ensured with this torque.
The device is mounted on the stand. The following steps describe the installation in the
connection compartment.
14
device on the stand.
Compact Operating Instructions, 07/2019, A5E35751632-AC
IFP1900 INOX PRO