Advertisement
(See Figure 5 for Steps 10-11: Removing the Power Supply Rear Panel and Power
Supply)
10. Remove power supply rear panel (3 screws located by On/Off Switch), using a T10 Torx
screwdriver. Save for reassembly.
11. Remove power supply (4 screws, 2 in rear frame and 2 in bottom board of power supply)
using a T15 Torx screwdriver (slide toward rear of unit, lift up, then slide toward front of
unit). Disconnect 3-wire (5-pin) cable assembly at power supply end. Save for reassembly.
Figure 5. Removing the Power Supply Rear Panel and Power Supply
HP E2479A Upgrade Procedures
8
Advertisement
