Installing - Miele 7080 850 Operating And Installing Instructions

13
Installing
e
Check correct position and operation of the kitchen unit
door
e
Run the mains cable so that the appliance can be con-
nected to the power supply when installed
e
Cut sealing strip
CD
to the height of the niche and fit it over
the gap between the appliance and the kitchen unit on the
same side as the handle.
Press strip a into the gap.
Strip b with adhesive strip: before pushing into the niche, re-
move the protective backing and affix to the side panel of the
kitchen unit.
e
Secure retaining bracket® to the appliance using the en-
closed screws.
e
Push appliance into the niche, leaving a gap of app. 4 mm
at the handle side (fig.
A).
Align the top and bottom front edges of support brackets®
with the front edge of the kitchen unit (not with the retaining
plates!)
(Detail X). Allow retaining bracket® to make contact with the
side panel (Detail Y).
e
Push the appliance against the side panel of the kitchen
unit (sealing strip compressed) and secure it at the top and
bottom with screws®. On the handle side, screw the appli-
ance to the side panel with the chipboard screw at the retain-
ing bracket®.
Break the stop off the retaining bracket and clip on cover
piece
0.
e
install door connecting element
CD
according to handle
height and door arrangement. Open the door fully, insert
connecting rail® and screw it to the kitchen unit door, allow-
~ing
for the thickness of the unit door
=
d (fig. B).
Adjust the connecting element so that the handle side of the
kitchen unit door does not make contact with the unit body
when closed (appl. 1 mm gap).
Fit a second connecting element if necessary.
e
Plug the exposed holes in the appliance door.
Fig. A
Fig. 8
25