Instructions For The Replacement Of Alkaline Batteries; Mounting - Siemens RDJ100 Programming Instructions Manual

Instructions for the replacement of alkaline batteries

Explosion due to fire or short-circuit, even with discharged batteries
Risk of injury due to flying parts
Prevent the batteries from coming into contact with water.
Do not recharge batteries.
Do not damage or disassemble batteries.
Do not heat batteries over 85°C.
Leakage of electrolyte
Severe burns
Handle damaged batteries only wearing suitable protective gloves.
In case of contact with electrolyte, rinse eyes immediately with plenty of water. Consult
a doctor.
Observe the following:
Use only a battery of the same type and from the same manufacturer as a replacement.
Observe the polarities (+/-).
The batteries must be new and undamaged.
Do not mix new and used batteries.
Store, transport and dispose of the batteries in compliance with local requirements,
regulations and laws. Also observe the instructions of the battery manufacturer.

Mounting

When mounting the device, attach the baseplate first. Then make the electrical connections,
and fit and secure the device (refer to the separate mounting instructions A6V10974419).
Mount the device on a flat wall and in compliance with local regulations.
If the reference room contains thermostatic radiator valves, set them to their fully open
position.
The devices are suitable for wall mounting.
Recommended height: 1.5 m above the floor.
Siemens
Building Technologies
WARNING
WARNING
Datasheet
9
A6V10954415_en--_e
2018-11-20