Adjusting The Transport Speed - Toro Greensmaster 04358 Operator's Manual

Figure 43
1. Traction cable
2. Bulkhead
3. Jam nuts
Note:
Loosen the nut securing the
eccentric to the top of the hydrostat
43).
B. Move the functional-control lever to the
N position and the throttle lever to
EUTRAL
the S position.
LOW
C. Start the engine.
D. Rotate the eccentric until creep does not
occur in either direction.
E. When the wheel stops rotating, tighten the
nut locking the eccentric and the adjustment
(Figure 43).
F. Verify the adjustment with the throttle lever
in the S
LOW
G. From each side of the bulkhead, tighten the
locknuts evenly, securing the traction cable
to the bulkhead
the cable.
Note:
If cable tension exists when the
functional-control lever is in the N
position, the machine may creep when you
move the lever to the M
position.
Adjusting the Transport
Speed
Obtaining the Maximum Transport
Speed
The traction pedal comes adjusted for
maximum-transport speed, but you may need
4. Eccentric
5. Locknut
and F position.
AST
(Figure 43). Do not twist
EUTRAL
or T
OW RANSPORT
to adjust it if the pedal reaches full stroke before it
contacts the pedal stop, or if you want to a decrease
the transport speed.
To obtain the maximum-transport speed, put the
functional control lever in the T
press down on the traction pedal. If the pedal contacts
the stop (Figure
cable, perform the following adjustment procedure:
g016466
(Figure
1. Pedal stop
1. Put the functional-control lever in the T
position and loosen the locknut securing the
pedal stop to the floor plate
2. Tighten the pedal stop until it does not contact
the traction pedal.
3. Continue applying a light load on the transport
pedal and adjust the pedal stop so it contacts
the pedal rod and tighten the nuts.
Important:
cable is not excessive or you will reduce the
cable life.
Reducing the Transport Speed
1. Press down on the traction pedal and loosen the
locknut securing the pedal stop to the floor plate.
2. Loosen the pedal stop until you obtain the
desired transport speed.
3. Tighten the locknut securing the pedal stop.
35
RANSPORT
44) before you feel tension on the
Figure 44
(Figure
Ensure that the tension on the
position and
g005520
RANSPORT
44).