Sony RS-232C Interface Manual page 44

MIC INPUT PARAMETER REQUEST : 52[H] 49[H] 4D[H] 31[H]-36[H] ('RIM1-6')
This command is used to read the setup of any desired single channel of the MIC input channels from the SRP-X700P.
The commands that correspond to the respective channels are shown below.
CHANNEL
MIC1/WL1
MIC2/WL2
MIC3
MIC4
MIC5/LINE1
MIC6/LINE2
• Packet format
52[H] 49[H] 4D[H] 31[H] "parameter" 0D[H]
(In the case of MIC1/WL1)
• Parameter
Specify the scene No. of the scene memory that you want to read, as the parameter.
Method of specifying the scene No. is the same as that of the GROUP FADER command. See page 29.
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] ('A')) in the
order shown below.
41[H] "parameter" 0D[H]
The parameter is the same as the 40 bytes of the MIC INPUT command parameter from which the scene No. is exempted.
MUTING/LINE4 SELECT : 43[H] 4D[H] 54[H] 53[H] ('CMTS')
This command is used to write the muting setup of the respective input/output channels and GROUP FADER, and the LINE4 SELECT setup
for each scene memory.
• Packet format
43[H] 4D[H] 54[H] 53[H] "parameter" 0D[H]
• Parameter
The parameter consists of the 8 bytes in the order as shown in the table below.
byte Parameter name
1st SCENE No.
2nd MIC MUTING
3rd LINE3,4 MUTING
4th LINE OUTPUT1-6 MUTING
5th LINE OUTPUT7,8/REC OUT/SPEAKER OUTPUT MUTING
6th MASTER MUTING
7th GROUP MUTING
8th LINE4 SELECT
Command
52[H] 49[H] 4D[H] 31[H] ('RIM1')
52[H] 49[H] 4D[H] 32[H] ('RIM2')
52[H] 49[H] 4D[H] 33[H] ('RIM3')
52[H] 49[H] 4D[H] 34[H] ('RIM4')
52[H] 49[H] 4D[H] 35[H] ('RIM5')
52[H] 49[H] 4D[H] 36[H] ('RIM6')
– 44 –