Sealing The Can - HP IndiChrome User Manual

Sealing the can

1
Spacer ring
2
3
Valve and prepared ink can
4
50 Chapter 4 General procedures
If the crimper is set to the Series 3000/4000/5000 and UltraStream-based level and
you are sealing a Series 1000/2000, TurboStream-based, or Sun computer-based
can, place the spacer ring on the round can base.
Spacer ring
Round
can base
Raise the crimper lever all the way up.
Put a valve on top of the prepared ink can.
Valve
Ink can
Push the round can base down, and carefully insert the can into the can crimper.
Make sure that the top of the can enters the crimper completely and that the can is
centered and flat on the round can base (or spacer ring if it is used) and not tilted.
Series 3000/4000/5000 and
UltraStream-based level
ENWW