Miele CS 1312 Operating And Installation Instructions page 11

~
Do not use the appliance as a
resting place for anything else. The
article could melt or catch fire if
residual heat is still present or if the
appliance is switched on by mistake.
~
Do not cover the appliance, e.g.
with a cloth, kitchen foil, etc. This could
be a fire hazard if the appliance is
switched on by mistake.
~
Never leave the appliance
unattended when it is switched on.
Overheated oil or residues of food or fat
on the lava rocks could flare up and
even set the cooker hood alight. Fire
hazard.
~
If, despite this, oil or fat does catch
fire, do not attempt to put out the flames
with water. Use a suitable fire blanket,
saucepan lid, damp towel or similar to
smother the flames.
~
When grilling or keeping food warm,
do not use grill pans, griddles,
saucepans or similar on the open grill,
and never cover the rack (e.g. with
aluminium foil) or use disposable
aluminium foil containers. The resulting
build-up of heat could damage the
rack.
Warning and Safety instructions
~
Clean the lava rocks regularly and
replace them when necessary. Rocks
which are saturated catch fire easily.
The grill trough and the lava rock
container should be cleaned after each
use to keep them free of oil and fat.
~
Always ensure that food is
sufficiently cooked or reheated. Many
factors will affect the overall cooking
time, including the size and quantity of
the food and its temperature.
Some foods may contain
micro-organisms which are only
destroyed by thorough cooking at a
sufficiently high temperature for long
enough. Therefore, when cooking or
reheating food such as poultry, it is
particularly important that the food is
completely cooked through. If in doubt,
select a longer cooking or reheating
time.
~
The grill trough must always be filled
with water whenever the grill is in use.
~
When using an electric socket near
the appliance, care should be taken
that the cable of the electrical
appliance does not come into contact
with the hot appliance. The insulation
on the cable could become damaged,
giving rise to an electric shock hazard.
The manufacturer cannot be held
liable for damage caused by
non-compliance with these Warning
and Safety instructions.
11