Table of Contents
Advertisement
L
n
IF
JUc
"
ati
to
iar
:im
rtn
"'
orr
'"
es
inr
fil
Table 2-1.
Accessories Supplied with the Communication Systems Analyzer
Equipment
Motorola Part No.
Use
Front cover
15-80335A 70
Front panel and CRT protection, storage of cables,
power cord, and other equipment for on-site
servicing.
Sun shade
15-80335A55
Snap over CRT during use in bright sunlight.
Power cord
30-80336A36
Three conductor cord to supply AC power to unit.
Also used when charging optional battery pack.
Oscilloscope probe
RTL-4058A
A X1 probe with attachments for general servicing.
In-line wattmeter adapter
RTL-4055A
Allows use of Motorola ST -1200 series in-line watt-
meter elements for direct measurement and display
of forward and reflected transmitted power.
Coax adapter
58-84300A98
Adapts front panel "N" connector to BNC female
Antenna
TEKA-24A
Plugs into RF in/out connector on front panel with
N to BNC adapter. Used for off-the-air transmitter
and receiver tests.
Test microphone
RTM-4000A
Used for voice modulation of signals.
Connector kit
RPX-4097A
Consists of connector shell, clamp, and four
connector pins. Used to fabricate a mating plug for
male de power connector at back of analyzer.
Enables user to make a de power cable to inter-
connect separate power source to analyzer. Pins 1
and 2 are positive, pin 3 is the charging line, pin 4 is
ground.
Table 2-2.
Optional Equipment for Use with Analyzer
Equipment
Motorola Part No.
Use
IEEE-488 Standard
Consult factory
Enables fully automatic testing with the unit
im
~rface
bus option
for retrofit
by external control from a computer or
information.
programmable controller.
2-5
Advertisement
Table of Contents
