ABB IRB 7600 Series Product Manual page 308

4 Repair
4.5.4.2 Unloading the balancing device using hydraulic press tool
Continued
Unloading the balancing device
The procedure below details how to use the press tool in order to unload the
balancing device. How to remove the press tool, is detailed in section
the balancing device using a hydraulic press tool on page
1
2
3
4
5
6
7
8
9
10
11
Continues on next page
308
Action
Fit the moving pin to the current press device.
Fit the correct press device and moving pin
to the press tool. Secure with the bolt, press
device.
Note
Make sure the bolt is secured properly!
Remove the rear cover of the balancing
device, by unscrewing the attachment screws.
DANGER
DO NOT! remove any other screws then the
rear cover attachment screws.
Remove the o-ring from the balancing device
end.
Remove the support shaft.
Fit the press tool to the rear of the balancing
device with enclosed bolts. Tighten them
properly!
Fit the hydraulic cylinder to the press tool.
Connect the hydraulic pump to the cylinder.
Increase the pressure and press until the
marking on the moving pin indicates the cor-
rect position (in level with the pressure block).
Turn the fix plate to position "Closed" in order
to lock the tool in loaded condition.
Unload the hydraulic cylinder.
© Copyright 2007 - 2018 ABB. All rights reserved.
310.
Note
Choose the correct press device, accord-
ing to the table Using the correct press
device on page 307.
The moving pin is shown in the figure
Press tool and hydraulic cylinder on
page 306.
Shown in the figure Press tool and hy-
draulic cylinder on page 306.
xx0200000175
• E: Rear cover attachment screws,
4 pcs
Art. no. is specified in Required equip-
ment on page 307.
See the figure Press tool and hydraulic
cylinder on page 306.
Art. no. is specified in Required equip-
ment on page 307.
See the figure Press tool and hydraulic
cylinder on page 306.
Art. no. is specified in Required equip-
ment on page 307.
See the figure Press tool and hydraulic
cylinder on page 306.
Do not apply more pressure than neces-
sary, it could damage bearings and
sealings at the shaft.
See the figure Press tool and hydraulic
cylinder on page 306.
Product manual - IRB 7600
3HAC022033-001 Revision: V
Restoring