Auto Tune; Manual Tune - Panasonic TY-FB8TA Operating Instructions Manual

AUTO TUNE

AUTO TUNE automatically retunes your set. This feature is useful if, e.g., you move house and wish to retune your
set to receive the local stations.
Press the MENU button.
Move to choose TUNING MENU.
Access TUNING MENU.
Move to choose AUTO TUNE.
Access AUTO TUNE.
Notes:
• If you proceed with the next step all tuning data will be erased (all stations and their programme
positions stored in your set's memory will be wiped out so the new settings can be stored).
• If you exit the procedure after this point and before AUTO TUNE is complete, no station information will
be stored. Restart and complete the AUTO TUNE procedure so that the set is retuned.
Press to start AUTO TUNE.
The set will search for, locate, store and then sort into
order your local stations.
Once this operation is completed the set will display the
programme now stored on programme position 1.
Press the MENU button at any time to go back to watching
TV (please read the Notes in the above procedure).

MANUAL TUNE

It is possible to retune individual programme positions:
Press the MENU button.
Move to choose TUNING MENU.
Access TUNING MENU.
Move to choose MANUAL TUNE.
Access MANUAL TUNE.
Select the programme position to be tuned.
Press repeatedly until required station is found.
When the desired station is found, press the OK button to
store. The programme position will flash.
Press the MENU button at any time to go back to watching TV.
Notes:
• If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the COLOUR SYS
selection on page 9.
• After the AUTO TUNE or MANUAL TUNE is finished, press the Programme Number up button to confirm the
tuning condition for each Programme Numbers. If some Programme Numbers are unused, it is possible to skip
such Programme Numbers. Please refer to the SKIP function on page 9.
• When using a VCR without video and audio input / output terminals, it is convenient to connect the aerial cable as
indicated in the instruction manual of VCR and to set the designated channel to Programme No."0". In that case,
perform MANUAL TUNE after setting the COLOUR SYS and SOUND SYS in advance. Further, in multi-system
VCR, it is more convenient to set the designated channel to several Programme Numbers.
Tuning
12
CH 12
AUTO SETUP IN PROGRESS
SEARCHING : PLEASE WAIT
STORED CH 12
MENU : TO EXIT
1
CH 12
PROGRAMME -/+
SEARCH -/+
STORE
EXIT
MANUAL TUNE
11