B.6 Security Setup Menu
The ezPORT setup provides both a Supervisor and a User password. If you use
both passwords, the Supervisor password must be set first.
The system can be configured so that all users must enter a password every time
the system boots or when ezPORT setup is executed, using either the Supervisor
password or User password.
Table B-6
AMI BIOS Security Menu
Main
Advanced
Security Settings
Supervisor Password
User Password
Change Supervisor Password
Change User Password
Clear User Password
Boot Sector Virus Protection
002.53 (C) Copyright 1985‐2002, American Megatrends, Inc.
To reset the security in the case of a forgotten password you must drain the
NVRAM and reconfigure.
B.6.1 To Clear the CMOS Password:
1. Turn off power to the unit.
2. Move switch S2 position 1 to On.
3. Wait approximately 5 seconds.
4. Move switch S2 position 1 to Off.
5. Power up the unit.
When the power is reapplied to the unit, the CMOS password will have been
cleared, and the CMOS will be set to its defaults.
BIOS SETUP UTILITY
PCIPnP
Boot
:
Not Installed
:
Not Installed
[Disabled]
Security
Chipset
Exit
Install or Change the
password.
←→
Select Screen
↑↓
Select Item
Enter Change
F1
General Help
F10
Save and Exit
ESC
Exit
Appendix B: AMI BIOS Setup Utility 64