Siemens SINUMERIK 840D sl Manual page 60

General information and networking
1.4 Networking
Recalibrate touch screen
Procedure:
1. The key combination below can be used to initiate further TCU calibration during operation,
if required: <F9> + <F10>.
This corresponds to the key combination on an OP: Menu back key + <MENU SELECT>.
2. Select the menu item "Calibrate touch screen" to start calibration.
Figure 1-22
Note
The "Touchware" program, which is available with Windows XP, is deactivated on the TCU.
The calibration process on the HT 8 can alternatively be started with the following key
combination: <Recall> + <MENU SELECT> and then the <U> key.
60
Operator panel service system - service menu for operator panel (TCU)
Show status
Show local logfile
Show logfile of remote devices
Modify operator panel settings
Calibrate touch screen
Reboot
Page
HT8 calibrating points
TOUCHSCREEN CALIBRATION
(Screen Orientation)
Please touch upper left corner
Page
Cancel
Ok
Operator panel front: OP 012
Manual, 09/2016, A5E36371591B