Dell EqualLogic PS4210 Installation And Setup Manual page 13

PS4210 Installation Guide
3. Connect the band to ground. You can either plug the banana connector into a matching
grounded receptacle, or attach it to the matching alligator clip and connect the clip to a
grounded device. Examples of an appropriate ground would be an ESD mat or the metal
frame of a grounded piece of equipment.
Shipping Box Contents and Required Hardware
Make sure you have all the items supplied in the shipping box, described in Table 1. You must
provide additional hardware that is specific to your environment and not included in the shipping
box. See Table 2.
Component Description
•
•
PS Series Array
•
Bezel
Power cables
One or two serial
cables
•
Documentation
•
•
•
Table 2: Additional Hardware Required (Not Included)
Component Description
Standard 19-in. Provides easy access to arrays and other hardware in your computing
four-post rack environment.
For use with a dedicated management network. Connects the Management port on
10/100Mbps the array to a 10/100Mbps network switch. Use Category 5E or Category 6 cables
Ethernet cables with RJ45 connectors. Use Category 5 cables only if they meet the TIA/EIA
TSB95 standard.
Connects devices (array) to a network. Multiple switches are recommended.
Network switch Switch provides 10GBASE-T interfaces to use the 10GBASE-T port, or an
SFP+ switch to use the SFP+ port.
CAT6 or CAT6A For 10GBASE-T port, use Category 6 (or better) cable for up to 55 meters. Use
cables Category 6A c able for up to 100 meters.
Optical o r copper
For SFP+ port, use optical cable or copper SFP+ cable.
cables
Table 1: Shipping Box Contents
Two Type 19 control modules
Two power supply and cooling modules
Up to 24 2.5-inch 10K or 12 3.5-inch 7.2K serial-attached SCSI (SAS,
Nearline SAS [NL-SAS], or Solid State (SSD) drives, depending on the
model suffix
The bezel mounts to the front of the array. The bezel identifies the array
model and protects the drives from unauthorized or accidental removal.
Connects an array power supply to power sources. I f power cables are not
included in the shipping box, contact your PS Series array support provider or
reseller.
Creates a serial connection between an array and a console or terminal
emulator. Use the cable to run the
to the array or group.
The following documentation is included in the shipping box:
Setup poster
Installation and Setup Guide (this document)
License, regulatory, and warranty information
Safety, Environmental, and Regulatory Information booklet
2 Rack Mounting the Array
utility i f there is no network access
setup
5