Setup Of The Modem Connected To The Fp Web-Server For Ppp-Communication - Panasonic FP Web-Server2 Hardware And Configuration Manual

Dial-in setup for PPP server
N o t e

14.1.3 Setup of the modem connected to the FP Web-Server for PPP-communication

Standard modem:
GSM modem:
138
If a Windows computer is set up to call up an Internet provider and to log
on to the Internet via modem (as with private Internet access), you
simply have to replace the telephone number of the Internet provider with
that of the FP Web-Server (i.e. the modem connected to it).
The modem has to be connected to the 9-pin RS232C port of the FP
Web-Server.
The modem must be set up to support RTS/CTS flow control.
Using the FP Modem-56k for PPP communication is recommended. Its
factory default setup can be used and it only needs to be connected via a
1:1 cable to the FP Web-Server.
RTS/CTS flow control needs to be enabled with AT&K3. To connect the
modem to the FP Web-Server, refer to PPP server with modem (see p.
175).
Standard computer modems should be reset to the factory default state
with the command AT&F&W. If there are connection problems, disabling
the autoanswer mode with ATS0=0 or the Keybreak function with AT%K1
helps with some modems.
 Be careful with the GSM antenna! Maintain distance to the other units
(PLC, modem, FP Web-Server...), as it may cause interference by high
level radio waves.
 Please reboot (power up) the FP Web-Server after changing cables and
connectors. Especially after connecting a modem / GSM module to the
FP Web-Server, it is necessary to restart the unit for modem
initialization and recognition.
FP Web-Server V2.810 EN