Siemens SINUMERIK Series Function Manual page 414

M1: Kinematic transformation
6.8 Activating transformation machine data via part program/softkey
but not, for instance:
MD24650 $MC_TRAFO5_BASE_TOOL_2
or
MD21110 $MC_X_AXIS_IN_OLD_X_Z_PLANE
Furthermore, another transformation (TRANSMIT) can be set, for example with MD24300
$MC_TRAFO_TYPE_3 = 256 and can be parameterized with additional machine data.
Defining geometry axes
Geometry axes must be defined before starting the control system with the following
machine data:
MD24120 $MC_TRAFO_GEOAX_ASSIGN_TAB_X[n]
or
MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB[n]
Changing the assignment
The assignment of a transformation data set to a transformation is determined by the
sequence of entries in MD24100 $MC_TRAFO_TYPE_X. The first entry in the table is
assigned to the first transformation data set, and accordingly the second entry to the second
data set. This assignment may (and can) not be altered for an active transformation.
Example:
Three transformations are set, two orientation transformations and one Transmit
transformation, e.g.
MD24100 $MC_TRAFO_TYPE_1 = 16
; orientation transformation, 1st orientation trafo data set
MD24200 $MC_TRAFO_TYPE_2 = 256 : Transmit transformations
MD24300 $MC_TRAFO_TYPE_3 = 18
; orientation transformation, 2nd orientation trafo data set
The first data set for orientation transformations is assigned to the first transformation
(equaling the first orientation transformation) and the second transformation data set to the
third transformation (equaling the second orientation transformation).
If the third transformation is active when the
permissible to change the first transformation into a transformation of another group (e.g.
TRACYL) since, in this case, the third transformation would then not become the second
orientation transformation, but the first.
In the above example, however, it is permissible to set another orientation transformation for
the first transformation (e.g. using MD24100 $MC_TRAFO_TYPE_1 = 32) or a
transformation from another group as the first transformation (e.g. using $MD24100
$MC_TRAFO_TYPE_1 = 1024, TRAANG), if the second transformation is changed into an
orientation transformation at the same time, e.g. with MD24200 $MC_TRAFO_TYPE_2 = 48.
414
command is executed, it is not
NEWCONFIG
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions