(12)Parameter access setting (Un\G10320)
Specify the parameter access method. When a value other than those below is stored, the parameter is read.
: Read (slave module master module CPU module)
• 0000
H
: Write (CPU module master module slave module)
• 0001
H
However, when the output signals below are executed, the set value is ignored.
• Parameter batch read command for the slave module (Y(n+1)1)
• Parameter batch write command for the slave module (Y(n+1)2)
(13)Parameter access target module ID specification (Un\G10321)
Specify the access ID for accessing the parameters of individual IDs.
Write one of the following to specify the ID.
• 0000
to 00FF
: ID of output slave modules
H
H
• 0200
to 02FF
: ID of an input slave module or I/O combined slave module
H
H
However, when the output signals below are executed, the set value is ignored.
• Parameter batch read command for the slave module (Y(n+1)1)
• Parameter batch write command for the slave module (Y(n+1)2)
APPENDICES
A
107