Table of Contents
Advertisement
s
Java User's Guide
11.5 Switching Java "System.out" to IDE Debug Window
97
11.5
Switching Java "System.out" to IDE Debug Window
The Java "System.out" can be redirected during a debugging session using a UDP socket con-
nection as described in
Section 5.9
"System Out" and
Section 5.9.3
"UDP". Switching between
Java "System.out" using serial port and Java "System.out" using UDP socket is done by a set-
ting inside of the emulator configuration file "WM_Debug_config.ini" (e.g. TC65 Release 2:
located under "TC65_R2\WTK\bin", TC65 Release 3: located Windows OS dependent under
"Application Data" folder as described in
Section
11.2). Switching Java "System.out" to serial
port is used as default setting.
Figure 57: Emulator configuration file "switching Java System.out to serial port"
The following line of the "WM_Debug_config.ini" file is used for switching the Java "System.out"
direction:
#UDPport=12345
To switch the Java "System.out" direction to the UDP socket and display it on a IDE window
please remove "#". The configuration line looks as follows:
UDPport=12345
To switch the Java "System.out" direction to serial port output please add "#" (default setting).
The configuration line looks as follows:
#UDPport=12345
Remarks:
Please keep in mind that the handling of Java "System.out" is done asynchronous. It is possi-
ble, that not all Java "System.out" data are written into the IDE window. To avoid this problem
please set a breakpoint in front of the Java function call "notifyDestroyed()" inside your Java
source.
Java "System.out" using IDE window is only supported during debugging session.
wm_java_usersguide_v12
Page 96 of 123
2008-02-25
Confidential / Released
Hide quick links:
Advertisement
Table of Contents
