Sony AC-T11 Service Manual page 19

2-1-7. Disassembly Procedure of the Printer MecHanism
0)
Remove head pressure contact springs (2-6| on both •ides.
<>}
Remove 2 E washer* (EW1.6).
; 3j Remove reinforcement piste (4-5)
© Remove idle gear J4-4).
Remove screw <M2x5) which holds the motor.
Remove motor side plate unit |l) (4-2). and rampva stepping
motor (4-1).
Sot wire holding |lg to pulley gear unit (2-1-17).
Remove pulley gear unit (2-1-17).
Detach the pulley mounting stand unit (2-3) upward.
Pull down the release lever (5-10) toward you.
Draw lira right aide of the carriage guide plate (2-1-13)
toward tho left and pull forward.
@ Remove screw (2-9) and remove platan (2-2).
Concave
§
Draw bearing (3-5) to the left to the tubber shaft (3-3).
Remove screws on both sides of the paper guide (B) (3-2).
While pressing the pa per guide (B) (3-2) downward, pul I tho
mhber roller shaft (3-3) to the right.
ji:
Remove E washor (EW2.6) of the release lever (6-10)
section, clutch stopper (6-12). release lever spring (5-11)
and the release lover in that Older.
@ Thn rubbm roller shaft, by the use of the concavo located at
the artow mark m tha fig., ia removed By pulling up from the
right side plate of the frame unit.
@ Remove paper guide (B) (3-2).
PRNT24(AE)
2-3