HP Indigo Division Series Instruction For Use & Installation Instructions page 49

At the engine front
9. To align the printing engines horizontally: (Figure 32):
For each printing engine
a. Remove three screws securing the ITM front bearing housing plate.
Save the screws for immediate reinstallation.
b. Install the alignment jig adapter on the plate. Insert the three screws previously
removed in the same holes.
Make sure of the following:
•
•
c. Mount the PE1 alignment jig (P/N MJX-3055-51) on the ITM end cap of PE1.
Make sure that the jig is oriented as shown in Figure 32.
Secure the jig using four screws.
d. Repeat step c for PE2 using its alignment jig (P/N MJX-3056-51).
The ITM heater cable is routed through the adapter inner groove.
The adapter is suitable for the plate and there is no gap between the plate
and the adapter. On some engines, three of the plate securing screws
protrude, and only the specific adapter suitable should be used.
CA294-03070 rev 00
Installation Manual
page 49 of 153