Operations - Bosch Connect S Manual

Connect S | Connect L | Asset Monitoring and Tracking Gateway

5 Operations

Activation:
To activate a new Connect gateway hold an active NFC scanning device on top of the housing. The gateway will start
automatically and connect to the Bosch server for firmware download and configuration.
Device status:
Some battery status information can be red from the LED:
LED
flashing green, 1s interval
flashing red, 1s interval
flashing red, 15s interval
flashing green, 30s interval
flashing red, 30s interval
no signal
red 1s + green 1s once
green constant
red constant
The Connect does not support a shutdown button. The device can only be turned off remotely.
Note: Connect Gateways must be off during flight transport!
Data subject not change without notice | Printed in Germany | June 06, 2016 | DRAFT
B S
ATTERY TATUS
Device is in standby
Device is operating: scan, GPS or upload running
Battery too low, device is in battery protection mode, no operation possible
Device is off, no operation. Battery ok. Device can be started by NFC activation.
Device is off, no operation. Battery low, device can be started after re-charge.
Battery too low, device is off. Recharge device.
Start triggered. device is starting application
With power supply connected. Battery charging. battery state > 90%
With power supply connected. Battery charging. battery state < 90%
7 | 13
Bosch Connected Industry