● The following text is also displayed when the cursor is placed on the parameter entry
The programming can only be completed after the incorrect value has been corrected.
Faulty parameter values are also monitored with alarms during the cycle runtime.
4.3.7
Setting data for cycles
The machine data for the technology selection is created for a specific channel as it is
possible, for example, that turning and milling is possible in the first channel, but only turning
in the second channel.
The following technologies can be set:
● Turning
● Turning + milling
The following setting data for cycles must be taken into account:
● MD52200 $MCS_TECHNOLOGY (technology):
● MD52201 $MCS_TECHNOLOGY_EXTENSION (extended technology):
Example: Turning machine with milling technology
● MD52200 = 1
● MD52201 = 2
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
field:
– 0: No specific configuration
– 1: Turning
– 2: Milling
– 0: No specific configuration
– 1: Turning
– 2: Milling
Programming a cycle
4.3 Fundamentals
147