Frigidaire BASELINE Series Use & Care Manual page 42

BEFORE YOU CALL
Concern Potential Cause
Opening/Closing Of Doors/Drawers
Door(s) will •
not close.
•
•
Drawers are •
difficult to
move.
•
Running of Refrigerator
Compressor •
does not run.
•
•
•
•
Refrigerator •
seems to run
too much or
too long.
Digital Temperature Setting Display
Digital •
temperature
displays an
error.
42
Door was closed too hard,
causing other door to open
slightly.
Refrigerator is not level.
It rocks on the floor when
moved slightly.
Refrigerator is touching a
wall or cabinet.
Food is touching shelf on
top of drawer.
Track that drawers slide on
is dirty.
Freezer control is set to
"OF".
Refrigerator is in defrost
cycle.
Plug at electrical outlet is
disconnected.
House fuse blown or
tripped circuit breaker.
Power outage.
Your variable speed
compressor is designed
to run 100% of the time
except during the defrost
cycle. At times it will run
faster, such as after a
defrost cycle.
Electronic control system
has detected a performance
problem.
Common Solution
• Close both doors gently.
• Ensure floor is level and solid, and can
adequately support the refrigerator.
Contact a carpenter to correct a sagging
or sloping floor.
• Ensure floor is level and solid, and can
adequately support the refrigerator.
Contact a carpenter to correct a sagging
or sloping floor.
• Remove top layer of items in drawer.
• Ensure drawer is properly installed on
track.
• Clean drawer, rollers, and track. See
Care & Cleaning.
• Set freezer control.
• This is normal for a fully automatic
defrost refrigerator. The defrost cycle
occurs periodically, lasting about 30
minutes.
• Ensure plug is tightly pushed into outlet.
• Check/replace fuse with a 15 amp time-
delay fuse. Reset circuit breaker.
• Check house lights. Call local electric
company.
• It is normal for the compressor to run
continuously except during defrost
mode.
• Call your Electrolux service
representative, who can interpret any
messages or number codes flashing on
the digital displays.