Set Private Vlan Port Type; Set Private Vlan Host Port - Yamaha L2 Command Reference Manual

166 | Command Reference | Layer 2 functions
• If you use the switchport trunk allowed vlan command to specify the associated VLAN ID, and then specify this
command, it is removed from the specified VLAN ID.
• If the VLAN ID specified by this command is associated using the switchport trunk allowed vlan command, switchport
trunk native vlan none is specified.
[Example]
Set LAN port #1 as the trunk port, and specify VLAN #2 as the native VLAN.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#switchport mode trunk
SWR2311P(config-if)#switchport trunk native vlan 2

6.2.10 Set private VLAN port type

[Syntax]
switchport mode private-vlan port-type
no switchport mode private-vlan port-type
[Parameter]
port-type
[Initial value]
none
[Input mode]
interface mode
[Description]
Specifies the private VLAN port type for the applicable interface.
If this is executed with the "no" syntax, the setting of the private VLAN specified for the applicable interface is deleted.
[Note]
This command can be set only for a LAN/SFP port for which the switchport mode access command is set.
In addition, promiscuous can be specified for the following interfaces.
• Interface that is operating as a trunk port
• logical interface
[Example]
Set LAN port #1 as a promiscuous port, and LAN port #2 as a host port.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#switchport mode private-vlan promiscuous
SWR2311P(config-if)#exit
SWR2311P(config)#interface port1.2
SWR2311P(config-if)#switchport mode private-vlan host

6.2.11 Set private VLAN host port

[Syntax]
switchport private-vlan host-association pri-vlan-id add 2nd-vlan-id
no switchport private-vlan host-association
[Keyword]
add
[Parameter]
pri-vlan-id
: Port mode
Setting value
promiscuous
host
: Sets the secondary VLAN for the primary VLAN
: <2-4094>
VLAN ID specified as the primary VLAN
Description
Promiscuous port
Host port