Verifying Devices Supporting Iqss Against System Configuration - Mitsubishi Electric IQSS-R-E Reference Manual

3.2
Verifying Devices Supporting iQSS Against
System Configuration
The system configuration displayed in the "AnyWireASLINK Configuration" window can be verified against the slave modules
connected to an AnyWireASLINK master module.
The result is displayed in the "Verification Result of the Configuration with the Connected Module" window.
Verify a system configuration when it is manually created or edited.
Operating procedure
2. Check
3. Click
The display is switched by right-clicking on the "Verification Result of the Configuration with the Connected
Module" window and selecting "Display All"/"Display Mismatch Only"/"Display other than Match".
■Verification methods of system configuration information
The system configuration information of AnyWireASLINK can also be verified by either of the following operations.
• Click the [Verify] button in the "AnyWireASLINK Configuration" window.
• Select [Online]  [Verification of the Configuration with the Connected Module] in MELSOFT Navigator. (FXCPU does not
support this function.)
For the operation methods of MELSOFT Navigator, refer to the following manual.
(Let's start iQ Works Version 2)
1. Select

3.2 Verifying Devices Supporting iQSS Against System Configuration

1.
Select [AnyWireASLINK Configuration]  [Online] 
[Verification of the Configuration with the Connected Module]
in the "AnyWireASLINK Configuration" window.
2.
When an automatic address detection is required, select the
"Execute Verification of the Configuration with the Connected
Module after Address Auto-recognition" checkbox, then click
the [Yes] button.
For a case in which an automatic address detection is required,
refer to the following manual.
MELSEC-Q/L AnyWireASLINK Master Module User's Manual
The verification results are displayed in the "Verification Result of
the Configuration with the Connected Module" window.
3 AnyWireASLINK
29
3