Dell EMC ML3 User Manual page 111

Table 36. Warning events (continued)
Event Code Message Text and Description
4060 Connection to the KMIP server failed.
4061 Key is not found on KMIP server.
4062 Key creation on KMIP server failed.
4063 KMIP configuration invalid.
4065 A tape alert flag was reported by a drive.
4067 Cleaning cartridge will soon expire and must
be replaced.
4072 No cleaning cartridge in logical library
available for auto cleaning
4073 Medium source element empty.
4074 Medium source element empty.
4075 Cartridge lost while it was extracted from
slot/drive.
4077 Unlocking the right magazine failed.
Details and Solution
v Verify the user name and password and all
needed SSL certificates that are needed for
connecting to the KMIP server.
v Verify that the KMIP server is reachable within
the network.
v Verify the IP addresses and host names of the
KMIP servers that are entered into the wizard.
Verify that the requested key is available on the
KMIP server. Check the KMIP server logs for
details.
Check the KMIP server logs for details about
why key creation failed.
Use the KMIP configuration wizard to verify the
KMIP configuration.
Look for logged TapeAlert flags and see its
description in the "TapeAlert flags" on page 95
section.
Replace the cartridge.
v Auto cleaning is enabled, but the logical
library contains no labeled cleaning cartridge.
The library was unable to complete the auto
clean function for one or more drives in this
logical library.
v Install a valid and labeled cleaning cartridge
into the logical library and then complete a
load and unload on the drive that needs
cleaned to initiate the auto cleaning.
Check the source slot visually and rescan the
inventory. Additionally, check for valid and
readable bar code label.
Check the source slot visually and rescan the
inventory. Additionally, check for valid and
readable bar code label.
Check the source/destination element and ensure
that no obstructions are in the pathway of the
accessor.
v Restart the library and retry the operation.
v If the error persists, replace the chassis.
v If the magazine needs to be removed to get
access to the tape cartridges, first power down
the device, and then release the magazine
manually. Only one magazine can be open at a
time.
89
Troubleshooting