Configuration Prerequisites; Configuration Procedure; Configuring Mld Proxying; Enabling Mld Proxying - HP MSR2003 Configuration Manual

Configuration prerequisites

Before you configure the MLD SSM mapping feature, complete the following tasks:
Configure an IPv6 unicast routing protocol so that all devices in the domain are interoperable at the
•
network layer.
• Configure basic MLD functions.

Configuration procedure

To configure MLD SSM mappings:
Step
1. Enter system view.
2. Enter MLD view.
3. Configure
mappings.

Configuring MLD proxying

This section describes how to configure MLD proxying.
Configuration prerequisites
Before you configure the MLD proxying feature, configure any IPv6 unicast routing protocol so that all
devices in the domain are interoperable at the network layer.

Enabling MLD proxying

To make the device serve as an MLD proxy, you can enable MLD proxying on the interface in the
direction toward the root of the IPv6 multicast forwarding tree.
Configuration guidelines
When you enable MLD proxying, follow these guidelines:
• You cannot enable MLD on an interface with MLD proxying enabled. If you configure other MLD
commands on such an interface, only the mld version command takes effect.
You cannot enable IPv6 multicast routing protocols (such as IPv6 PIM) on a device with MLD
•
proxying enabled.
Configuration procedure
To enable MLD proxying:
Step
1. Enter system view.
Command
system-view
mld [ vpn-instance
vpn-instance-name ]
MLD SSM
ssm-mapping ipv6-source-address
acl6-number
Command
system-view
264
Remarks
N/A
N/A
By default, no MLD mapping is
configured.
Remarks
N/A