Functions - Yamaha CXS18XLF Owner's Manual

Functions

Front
q Dual pole sockets
Compatible with commercially available speaker poles of
35 mm diameter and M20 screws.
35 mm diameter
If you use the pole socket for mounting of a satellite
speaker, observe the conditions below for your safety.
Subwoofer Speakers to be mounted
Weight: 26 kg or less
Height: 76.0 cm or less
CXS18XLF
(CZR15 or smaller)
Weight: 22 kg or less
Height: 64.5 cm or less
(CZR12 or smaller)
CXS15XLF
Weight: 18 kg or less
Height: 53.7 cm or less
(CZR10 or smaller)
w Feet cups
When stacking multiple speakers, align the rubber feet of
the upper speaker to the feet cups of the lower one.
e Wheel mounting screws
For installing the optionally available Yamaha SPW-1
wheels. To install the wheels, use these screws after
removing them from the unit. Do not use the CXS once the
screws are removed. This causes air leaks to occur in the
enclosure, resulting in undesirable performance.
6 CXS series Owner's Manual
Rear
q
w
e
• For details on installing the wheels or special precautions you
• Do not install any wheels other than the SPW-1.
rt [INPUT/PARALLEL] jacks
These are speakON jacks (Neutrik NL4). Either r or t
M20 screw
can be connected since they are connected in parallel
inside. The speaker unit is connected to the 1+/1– con-
tacts of the [INPUT/PARALLEL] jacks.
Pole length
104 cm or less
82 cm or less
y [OUTPUT] jack
104 cm or less
This speakON jack is for use with a full-range speaker
through CXS, or when using CXS in the cardioid mode.
This jack receives the signals via 2+/2– of r or t and
routes them to 1+/1– for output.
r
t
r
t
NOTE
should take, please refer to the corresponding manual for the
wheels.
speakON plug
Insert all the way inside
and turn to lock
INPUT
1+/1–
2+/2–
PARALLEL
1+/1–
2+/2–
y
OUTPUT
y
1+/1–
(2+/2–:
Unconnected)