Operating Instructions; Heater Operation; Temperature Setting; Remote Control - Kenmore 127.96012610 Use & Care Manual

OPERATING INSTRUCTIONS

HEATER OPERATION

Always operate the heater in the upright position following all instructions and
recommendations listed in this manual.
HEATER LOCATION
Place the heater in the area of the room that is coldest.
HEATER CONNECTION
outlet. A loose connection may cause overheating and damage to the plug or heater.
NOTE: To prevent overloading a circuit, do not plug the heater into a circuit that
is servicing other electrical needs.
The heater may be operated by the controls located on the heater (see Fig. ) or by
the remote control (see Fig. .
1. Carefully remove the heater/fan from the plastic bag and the carton.
surface.
3. Power On the unit by switching on the
then show the current room temperature.
4. Turn the heater ON by pressing the
button on the control panel or remote
control.
5 . Regardless of the difference between room temperature and heater setting, you
HIGH or FAN mode.
6 .
automatically when sufficiently cooled down.
OSCILLATING FUNCTION
The Oscillating function will work in any mode.
1. Press the button to oscillate the heater fan from left to right across a 90
degree arc. The indicator symbol will display on the heater control panel.
button again.
6
Power Switch (Fig.1). The control
OPERATING INSTRUCTIONS
TIMER FUNCTION
The Timer function will work in any mode. The Timer function allows you to set the
length of operation from 1 to 8 hours. Each time the
of operation will increase 1 hour. The duration the timer is set for will be displayed
on the LED screen in hour increments. TO TURN THE TIMER FUNCTION
the E

TEMPERATURE SETTING

1. may the desired temperature setting in any heater operation mode.
The temperature can be set from to
2. Press the or button to the temperature setting.
The heater will operate in HEAT mode and blow warm air when the set
temperature is higher than the room temperature.
The heater will operate in HIGH HEAT mode and blow hot air when the set
temperature is more than higher than the room temperature.
When the room temperature reaches the set temperature the heater will
automatically go into FAN and blow unheated air.
The heater will cycle between FAN
maintains the set temperature.
SAFETY FEATURES
The heater must cool down and be reset before it will
On. Press the (l) button on the control panel to resume normal operation.
the heater is on a surface with no obstructions. The heater is also
ped with a safety switch to turn power off to the heater when the
heater tips To resume heater functions simply stand heater upright. With tip
protection, the heater will only operate when placed upright on a

REMOTE CONTROL

The remote control uses one button cell battery, type
the remote. See Fig. 4. We recommend the use of a
use. Follow battery disposal instruction on battery
local safety council for safely disposal of batteries.
using the remote
Fig. 4
control, you must
the insulating film as shown
in the figure below.
1. All functions performed
Remote control
identically to the heater
control panel.
Aim the remote control at
the heater control panel to operate the heater.
7
button is pressed the length
and HEAT as it
sure that
surface.
battery for longer
, or contact your
Insulating film Battery carriage
PULL
Release Tab