SNMP Support Details
The CS-700 includes an SNMP agent that can be configured to provide SNMP
support.
The table below describes the SNMP configuration settings that the CS-700
administrator must configure to enable SNMP.
snmp-enable
snmp-address
snmp-community
snmp-contact-name
snmp-device-location
The following read-only properties and traps are supported.
Read-only Properties
Serial number
MAC address
Base FW version
USB connection active (0,1)
USB microphone audio stream active (0,1)
USB speaker audio stream active (0,1)
USB video stream active (0,1)
Bluetooth connection active (0,1)
VoIP call active (0,1)
Traps
USB connection state changes
Dialer battery level is low (<10%)
Enable or disable SNMP support. Disabled (0) means that SNMP is not
supported. Enabled (1) means that SNMP is available. Default is 0.
Specifies SNMP server address to which traps will be sent. Leave blank to
disable traps.
Specifies the SNMP read-only community string used for queries from the
server and transmitted traps. Read-only indicates the authorization level.
The device does not support write operations initiated through SNMP.
Default value is 'public'.
Specifies the contact name, typically the system administrator. This string
is informational and can include an email address. It is not associated with
traps.
Specifies the location of the device for informational purposes.
94