Dr 23 S Cale Parameter 2 (Awi) - Siemens SIWAREX FTA Device Manual

Status output condition
Net weight from TU1 to TO1
Net weight above TO1 to TO2
Net weight above TO2
Net weight from TU2 to under TU1
Net weight under TU2
Table 5-15 Tolerance information evaluation
5.16 DR 23 Scale parameter 2 (AWI)
Weighing parameters are held in DR23. These are normally typical to the scale
and do not depend heavily on the changing material properties within a limited
extent. Procedure:
o
Adjust all parameters corresponding to their purpose
o Send DR 23 to the scale
o If required, check parameters using tests
Name
Scale parameter 2
Text selection for BYTE
automatic logging
Reserve 1 BYTE
Filter depth of average WORD
value filter for dosing
Max. single set weight REAL
Inhibition time coarse TIME
Inhibition time fine TIME
Inhibition time Set-Act- TIME
comparison
Default value for analog BYTE
output with coarse
Default value for analog BYTE
output with fine
SIWAREX FTA
Type Address Default
0
DBB000 1
DBB001 0
DBB002 0
DBD004 90
Wizzard:
WB
nmax
DBD008 500
DBD012 500
DBD016 0
DBB020 60
DBB021 40
TO2 TO1 Good
0 0 1
0 1 0
1 0 0
0 0 0
0 0 0
Range of Values / Explanation
0: No autom. logging after the
weighing procedure
1: autom. logging with text 1
2: autom. logging with text 2
3: autom. logging with text 3
4: autom. logging with text 4
Other definitions not permitted.
Reserve 1
0 ...250
0: average value filter deactivated
Other definitions not permitted.
Maximum set weight for a single
*
0: deactivated
After switching the coarse signal on, no weight
evaluation is performed for the defined amount of
time (msec)!
0: deactivated
After switching the coarse signal off, no weight
evaluation is performed for the defined amount of
time (msec)!
After the command for starting the inhibition time,
the actual weight is not monitored during the
weighing procedure for the defined amount of
time.
Analog output value if coarse signal active (in %)
Analog output value if fine signal active (in %)
Weighing Functions
TU1 TU2 Off
0 0 0
0 0 0
0 0 1
1 0 0
0 1 1
Reference
5.16.1
5.16.9
5.16.2
5.16.3
5.16.4
5.16.5
5.16.6
5.16.7
5-95