Table of Contents
Advertisement
Enter a new password in the box "New password".
Then, enter the password again in the box "Confirm
new password". After the entry, click on "OK".
Version (V): When you click on this item, the version of
the setup software is displayed. When you click
"OK", the window will be closed.
● Buttons
• Load Button
The setting is loaded from the iris reader into the setup soft-
ware.
• Store Button
The setting is stored into the iris reader. The setting is acti-
vated when the power is supplied to the iris reader again or
the iris reader is reset.
• Close Button
The system setup software is quitted.
● Setting Parameters
ET330 ID: The ID of iris reader is entered in a decimal num-
ber.
1 to 99999 is available. The ID should be same as what
is set in the administration software.
Default setting: 1
• Network Setting Parameters
ET330 IP Address: The IP address of iris reader is
entered.
Default setting: 192.168.0.3
Server IP Address: The IP address of iris server is
entered.
Default setting: 192.168.0.2
Gateway IP Address: The IP address of gateway of the
network, to which the iris reader is connected, is
entered.
Default setting: 192.168.0.1
Subnetmask: The subnet mask of the network, to
which the iris reader is connected, is entered.
Default setting: 255.255.255.0
15
Advertisement
Table of Contents
