Controlling Combo Devices - GE 34455 Instruction Manual

Programming Your Remote
Did the device turn off?
• If YES, you have found a code for the
device. Press and release the same device
button you pressed in Step 3. This will store
the code in the remote. Go to step 7.
• If NO, continue to press and release the
strm
VOL + button until the device turns off to
test the other 9 codes from Step 4. Be sure
to wait approximately 3 seconds after each
VOL + button press to allow the device time
to respond to the code. When the device
turns off, you have found a code for your
device. Press and release the same device
button pressed in Step 3. This will store the
code in the remote. Go to Step 7.
Special Notes:
• The VOL – button can be used to go backwards
through each batch of 10 codes.
• The red indicator light will flash 2 times after testing
the first or last code in each batch of 10.
7. Use the remote to turn the device back on.
Test the buttons on the remote to see if the
device responds as you would expect. If the
buttons do not operate the device, return to
Step 2 and repeat this process to search for
a better code to operate the device.
8. Repeat this process for each device you
wish to control.
strm

Controlling Combo Devices

Some combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR,
etc.) will require you to set up two different device
buttons to control both parts of the combo device.
For example, if you have a TV/DVD combo, you may
need to set up one code under the TV button to
control the TV and a separate code under the dvd
button to control the DVD.
input
ch
input
enter
ch
9