en
CHAPTER 9
9.3.4 Configuration repeater
Note
The repeater must be programmed with the DECT6000
service tool. This programming device must be connected to the
power-inlet/programming connector.
The hardware package consists of two items, a serial cable
and a modular
connector adapter
.
2
1
Figure 9.6 Connection of the serial cable and modular connector adapter
1. Connect the serial cable to the modular connector adapter. There is no
requirement as to polarity or position of the connectors.
2. Connect the modular connector adapter to the repeater.
3. Connect the mains adapter to the mains.
4. Connect the serial cable to the COM-port of your computer.
5. Switch on your laptop.
6. Program the repeater.
Installation Instructions
DECT6000
33