Changing A Cycle Call; Compatibility For Cycle Support; Additional Functions In The Input Screens - Siemens SINUMERIK 840D sl Operating Manual

Creating a G code program
8.9 Calling technology cycles
8.9.5

Changing a cycle call

You have called the desired cycle via softkey in the program editor, entered the parameters
and confirmed with "Accept".
Procedure
See also
Generating a G code program (Page 222)
8.9.6

Compatibility for cycle support

The cycle support is generally upwards compatible. This means that cycle calls in NC programs
can always be recompiled with a higher software version, changed and then run again.
When transferring NC programs to a machine with a lower software version, it cannot be
guaranteed, however, that the program will be able to be changed by recompiling cycle calls.
8.9.7

Additional functions in the input screens

Selection of units
232
1. Select the desired cycle call and press the <Cursor right> key.
The associated input screen of the selected cycle call is opened.
- OR -
Press the <SHIFT + INSERT> key combination.
This starts the edit mode for this cycle call and you can edit it like a normal
NC block. This means that it is possible to generate an empty block before
the cycle is called. For instance, to insert something before a cycle that
is located at the beginning of the program.
Note: In edit mode, the cycle call can be changed in such a way that it
can no longer be recompiled in the parameter screen.
You exit the edit mode by pressing the <SHIFT + INSERT> key combi‐
nation.
- OR -
You are in the edit mode and press the <INPUT> key.
A new line is created after the cursor position.
If, for example, the unit can be switched in a field, this is highlighted as soon as the cursor
is positioned on the element. In this way, the operator recognizes the dependency.
The selection symbol is also displayed in the tooltip.
Operating Manual, 05/2017, A5E40868721
Turning