Water Quality; Frost Protection - LG ARNH08GK3A2 Installation Manual

Hydro kit
Hide thumbs Also See for ARNH08GK3A2:
Table of Contents

Advertisement

Water Quality

Water quality should comply with EN 98/83 EC Directives. Requirement for resolved chemical ingre-
dients is following table. Detailed water quality condition can be found in EN 98/83 EC Directives.
Parameter
Acrylamide
Antimony
Arsenic
Benzene
Benzo(a)pyrene
Boron
Bromate
Cadmium
Chromium
Copper
Cyanide
1.2-dichloroethane
Epichlorohydrin
CAUTION
• If the unit is installed at existing hydraulic water loop, it is important to clean hydraulic pipes to remove
sludge and scale.
• Installing sludge strainer in the water loop is very important to prevent performance degrade.
• Chemical treatment to prevent rust should be performed by installer.

Frost protection

In areas of the country where entering water temperatures drop below 0℃(32℉), the water pipe must
be protected by using an approved antifreeze solution. Consult your Hydro Kit unit supplier for lo-
cally approved solutions in your area. Calculate the approximate volume of water in the system. (Ex-
cept the Hydro Kit unit.) And add antifreeze solution to the total volume to allow for the water
contained in Hydro Kit unit.
Type of Antifreeze
Ethylene glycol
Propylene glycol
Methanol
CAUTION
1. Use only one of the above antifreeze.
2. If a antifreeze is used, pressure drop and capability degradation of the system can occur.
3. If one of antifreezes is used, corrosion can occur. So please add corrosion inhibitor.
4. Please check the concentration of the antifreeze periodically to keep same concentration.
5. When the antifreeze is used (for installation or operation), take care to ensure that antifreeze
must not be touched.
6. Ensure to respect all laws and norms of your country about Anti-freeze usage.
7. When hydro kit is applied for heating, the antifreeze never added in the water circuit.
Value
0.10 μg/
5.0 μg/
10 μg/
1.0 μg/
0.010 μg/
1.0 mg/
10 μg/
5.0 μg/
50 μg/
2.0 mg/
50 μg/
3.0 μg/
0.10 μg/
Minimum Temperature for Freeze Protection
0℃(32℉)
-5℃(23℉)
0%
12%
0%
17%
0%
6%
Parameter
Fluoride
Lead
Mercury
Nickel
Nitrate
Nitrite
Pesticides
Pesticides — Total
Polycyclic aromatic hydrocarbons
Selenium
Tetrachloroethene and Trichloroethene
Trihalomethanes — Total
Vinyl chloride
-10℃(14℉)
-15℃(5℉)
20%
30%
25%
33%
12%
16%
Hydro Kit Installation Manual 17
Installation
Value
1.5 mg/
10 μg/
1.0 μg/
20 μg/
50 mg/
0.50 mg/
0.10 μg/
0.50 μg/
0.10 μg/
10 μg/
10 μg/
100 μg/
0.50 μg/
-20℃(-4℉) -25℃(-13℉)
-
-
-
-
24%
30%

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Arnh04gk3a2

Table of Contents