Configuring Routing Between An Mce And A Pe - HP FlexNetwork 10500 Series Configuration Manual

Configuring routing between an MCE and a PE

MCE-PE routing configuration includes the following tasks:
•
Binding the MCE-PE interfaces to IPv6 VPN instances.
•
Performing routing configurations.
•
Redistributing IPv6 VPN routes into the routing protocol running between the MCE and the PE.
Perform the following configuration tasks on the MCE. Configure the PE in the same way that you
configure a PE in a basic IPv6 MPLS L3VPN. For more information about configuring the PE, see
"Configuring IPv6 MPLS
Configuring IPv6 static routing between an MCE and a PE
Step
1. Enter system view.
2. Configure an IPv6
static route for an IPv6
VPN instance.
3. (Optional.) Set the
default preference for
IPv6 static routes.
Configuring RIPng between an MCE and a PE
Step
1. Enter system view.
2. Create a RIPng process for
an IPv6 VPN instance and
enter RIPng view.
3. Redistribute VPN routes.
4. Return to system view.
5. Enter interface view.
6. Enable the RIPng process on
the interface.
Configuring OSPFv3 between an MCE and a PE
Step
1. Enter system view.
2. Create an OSPFv3 process
for an IPv6 VPN instance
and enter OSPFv3 view.
L3VPN."
Command
system-view
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ]
| vpn-instance d-vpn-instance-name
nexthop-address } [ permanent ] [ preference
preference ] [ tag tag-value ] [ description text ]
ipv6 route-static default-preference
default-preference
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ allow-direct | cost
cost-value | route-policy
route-policy-name ] *
quit
interface interface-type
interface-number
ripng process-id enable
Command
system-view
ospfv3 [ process-id |
vpn-instance
vpn-instance-name ] *
452
Remarks
N/A
By default, no IPv6 static
routes are configured.
The default value is 60.
Remarks
N/A
N/A
By default, no routes are
redistributed into RIPng.
N/A
N/A
By default, RIPng is disabled
on an interface.
Remarks
N/A
N/A