Clock-Out - Panasonic 5000 Series Operating Instructions Manual

Time & Attendance
4. Check the data (name and job code) on your screen. If an error exists, press
CLEAR and start over. If everything is correct, press CLOCK IN.
[ employee # ]
Note: If you use employee cards, press CLOCK IN. Swipe the card through the Reader.
Enter your job code number and press CLOCK IN again.

Clock-Out

Use the Clock-Out procedure when you clock out at the end of a shift. If you are not
compensated for breaks, you may also use this procedure when you leave at the beginning
of a break.
1. Enter your employee number.
2. Press CLOCK OUT.
3. Make sure the displayed information is correct. If you entered the wrong number,
press CLEAR and start over.
4. If everything is correct, press CLOCK OUT again. If MGR Mode is required, turn
the keylock to MGR Mode before performing the steps below.
[ employee # ]
Note: If you use employee cards, press CLOCK OUT. Run your card through the Magnetic
Card Reader. Then press CLOCK OUT again.
Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0
CLOCK
[ job code # ]
IN
*** TIME IN
#002 STEVE
MGR
CSHR #1
NOV.15'94
No1838 11:30
CLOCK
[ verify information ]
OUT
CLOCK
IN
***
JOB 1
0001
#01
OPERATOR PROCEDURES
CLOCK
OUT
2-59