Page 3
Care and cleaning • Make sure that the electrical information on the rating plate agrees with the power supply. • Before you clean the appliance, deactivate it and dis- • Always use a correctly installed shockproof socket. connect the mains plug from the mains socket. •...
Control panel On/off indicator Programme marker Indicators Delay start button Start/cancel button Programme knob Indicators End indicator. It comes on in these conditions: • When the washing programme is completed. • When you adjust the level of the water softener. •...
• To cancel a washing programme in progress. Refer to • To adjust electronically the level of the water softener. 'Select and start a washing programme'. Refer to 'Setting the water softener'. Washing programmes Programme Programme Degree of soil Type of load Programme description knob position Intensive 70°...
Use of the appliance 1. Be sure that the set level of the water softener agrees 5. Set the correct washing programme for the type of with the water hardness in your area. If not, adjust the load and soil. water softener.
Manual adjustment 2. Turn the programme knob clockwise until the pro- gramme marker is aligned with the first washing pro- gramme. 3. Release the start/cancel button when the on/off indi- cator and the start/cancel indicator start to flash. • At the same time, the end indicator flashes inter- mittently.
Use of detergent and rinse aid Do these steps to fill the rinse aid dispenser: 1. Press the release button to open the lid of the rinse aid dispenser. 2. Fill the rinse aid dispenser with rinse aid. The mark 'max' shows the maximum level. 3.
Loading cutlery and dishes Hints and tips • Do not put in the appliance items that can absorb water (sponges, household cloths). • Remove the remaining food from the items. • Make soft the remaining burned food on the items. •...
Do these steps to move the upper basket to the higher po- sition: 1. Move the front runner stops (A) out. 2. Pull the basket out. 3. Put the basket in the higher or lower position. 4. Put back the front runner stops (A) in their initial po- sition.
Care and cleaning To remove and clean the filters Dirty filters decrease the washing results. Put the flat filter A in the Put the filter system in po- sition. To lock the filter bottom of the appliance. Install the flat filter cor- system, turn the handle Clean the filters below rectly under the two...
Page 12
Warning! Deactivate the appliance before you do the checks. Malfunction Possible cause Possible solution The appliance does not fill with water. The water tap is blocked or there is Clean the water tap. limescale on it. The water pressure is too low. Contact your local water authority.
The washing results and drying results are not satisfactory Problem Possible cause Possible solution The dishes are not clean. The selected washing programme Make sure that the washing pro- was not applicable for the type of gramme is applicable for the type of load and soil.
Capacity Place settings 1) Connect the water inlet hose to a water tap with a 3/4'' thread. The rating plate on the inner edge of the appliance aeolian), use a hot water supply to decrease energy con- door shows the electrical connection data. sumption.
Page 15
The drain hose extension must not be longer than 2 m. The internal diameter must not be smaller than the diame- ter of the hose. If you connect the water drain hose to a trap spigot under the sink, remove the plastic membrane (A). If you do not remove the membrane, remaining food can cause a block- age in the drain hose spigot...