Cisco TelePresence SX10
Introduction
xCommand UserInterface Presentation ExternalSource State Set
Set or change the state of the input source (specified by the SourceIdentifier).
Requires user role: ADMIN, INTEGRATOR, ROOMCONTROL
USAGE:
xCommand UserInterface Presentation ExternalSource State Set SourceIdentifier:
"SourceIdentifier" State:
State
where
: String (0, 40)
SourceIdentifier
The unique string that identifies this input source. It was defined when the source was
created with the UserInterface Presentation ExternalSource Add command.
: Hidden/Ready/NotReady/Error
State
Ready: The input source will be presented when someone selects it (taps it on the user
interface, or when the UserInterface Presentation ExternalSource Select command is
issued).
NotReady: The input source is not ready, and cannot be selected.
Error: The input source is in an erroneous state. The ErrorReason parameter may be
used to inform the user about the reason for failure.
Hidden: The input source will not be displayed in the user interface sharetray.
: String (0, 80)
ErrorReason
This string is displayed in the user interface sharetray, given that the State parameter is
set to Error.
Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017.
D15333.07
About the API
xConfiguration
[ErrorReason: "ErrorReason"]
xCommand
xCommand
UserManagement commands
xCommand UserManagement RemoteSupportUser Create
Create a remote support user passphrase that Technical Assistance Center (TAC) can use to
access the system for troubleshooting.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Create [ExpiryDays: ExpiryDays]
where
: Integer (1..31)
ExpiryDays
Define the duration for the passphrase validity. Default is 7 days.
xCommand UserManagement RemoteSupportUser Delete
Delete the remote support user created with the command xCommand UserManagement
RemoteSupportUser Create.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Delete
xCommand UserManagement RemoteSupportUser DisablePermanently
Disable the creation of new remote support users. To enable the remote support user again you
must factory reset your system.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser DisablePermanently Confirm:
where
: Yes
Confirm
123
API Reference Guide
xStatus
Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.
Confirm