Voyager 1602g Wireless Area-Imaging Pocket Scanner Quick Start Guide Aller à www.honeywellaidc.com pour le français. Vai a www.honeywellaidc.com per l'italiano. Gehe zu www.honeywellaidc.com für Deutsch. Ir a www.honeywellaidc.com para español. Idź na stronę : po quick start w języku polskim.
Note: Refer to your User’s Guide for information about cleaning your device. Getting Started The scanner’s battery must be fully charged before the first use. It can be charged using a power supply or by connecting the USB cable to a computer. Charging via Power Supply: Note: The power supply must be ordered separately, if needed.
Connecting the Scanner to a USB port: Turn off the computer’s power before connecting the scanner, then power up the computer once the scanner is fully connected.
Battery Charge Indicator When the battery is charging, the small LED at the top left of the scanner flashes orange. When the battery is fully charged, this LED is solid green. Reading Techniques The scanner projects an aiming beam that should be centered over the bar code, but it can be posi- tioned in any direction for a good read.
Standard Product Defaults Using the Scanner with Bluetooth Devices The scanner can be used either with a Honeywell Access Point (AP01-XXXBT) or with other Bluetooth devices. Those devices include personal computers, laptops, and tablets. 1. Scan the Bluetooth HID Keyboard Connect bar code below.
successful pairing message and you do not need to continue to the next step. 4. If your personal computer, laptop, or tablet does not automatically pair with the scanner, a PIN is displayed. This PIN must be scanned within 60 seconds. You must quickly scan Bluetooth PIN Code below, then scan the numeric bar code(s) for the PIN code from the Programming...
Keyboard Country Your keyboard layout default is a US keyboard. To change this lay- out, refer to the following chart for your keyboard country. Scan the Program Keyboard Country bar code, then scan the numeric bar code(s) for the appropriate Country Code from page 2, then scan the Save bar code.
Suffix If you want a carriage return after the bar code, scan the Add CR Suffix bar code. To add a tab after the bar code, scan the Add Tab Suffix bar code. Otherwise, scan the Remove Suffix bar code to remove the suffixes.
Function Code Transmit When this selection is enabled and function codes are contained within the scanned data, the scanner transmits the function code to the terminal. Charts of these function codes are provided in your User’s Guide. When the scanner is in keyboard wedge mode, the scan code is converted to a key code before it is transmitted.
Data Format Editor Instructions The following are abbreviated instructions for entering a data format. For complete instructions refer to your User’s Guide, available at our website, www.honeywellaidc.com. 1. Scan the Enter Data Format symbol. 2. Primary/Alternate Format: scan 0 for Primary Format 3.
For localized versions of this document, and to download the User’s Guide, go to www.honeywellaidc.com. Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made.
Page 14
This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of HII. 2015 Honeywell International Inc. All rights reserved. Web Address: www.honeywellaidc.com...