Samsung DCS Programming Manual page 189

SAMSUNG MMC PROGRAMS
COMBINED SYSTEMS PROGRAMMING MANUAL FEBRUARY 2004
FIRST DIGIT: Controls how long the system will wait for dialling to begin before dropping the dial tone
and returning the user to error tone.
HOK FLASH MAX: Monitors the duration of a hookswitch flash to ensure that the flash is valid and
not a line noise or an accidental hookswitch bounce (LONGEST DURATION).
HOK FLASH MIN: Monitors the duration of a hookswitch flash to ensure that the flash is valid and not
a line noise or an accidental hookswitch bounce (SHORTEST DURATION).
HOOK OFF: Controls the time before dial tone is sent to a single line station, or a ringing call is an-
swered.
HOOK ON: Sets the minimum amount of time that the system will recognise as an SLT hang up.
(Must be greater than HOK FLASH MAX.)
INQUIRY RELEASE: Monitors the duration of the action of the soft key to determine when to return
the LCD back to a normal status. This timer affects only display phones.
INTER DIGIT: Controls the grace period between dialling valid digits before dropping the call and re-
turning the user to error tone.
ISDN INT DGT: Controls the grace period between dialling valid digits and the end of the dialling
string on an ISDN call.
KMMC LOCK OUT: Controls the grace period between programming actions while in a programming
session (KMMC not PCMMC). The timer automatically returns the system to secure programming
status.
LCR ADVANCE: Controls the period of time before selecting the next allowable route when a station
is allowed to route advance.
LCR INTER DIGIT: Controls the grace period between dialling valid digits before dropping the call
and returning the user to error tone.
LONG KEY DETECT: Controls the period for which pressing and holding a key will dial the corre-
sponding single-digit personal speed dial number.
LONG KEY REPEAT: Controls the period for which pressing and holding a key will dial the corre-
sponding multiple (same) digit personal speed dial number (e.g. 22).
MCL DELAY: Controls the time when the system should start transmitting Authorisation Code after
sending MCL access code (Cable & Wireless 131 access).
MS LED ON: Controls the time for which a Manual Signalling key LED will flash when the key is
pressed.
OFF HOOK RING: Controls the duration of time between ring bursts to a user who has a camped-on
call.
OFF HOOK SELECT: Controls the grace period between lifting the handset and placing an inter-
nal/external call as programmed in MMC 306. (iDCS and OS500 systems use the OFFHK SEL fea-
ture in MMC 502.)
OHVA ANSWER: Controls the duration of an OHVA call before automatic rejection. When a user re-
ceives OHVA with voice interrupt, this situation will last until this timer expires. If LCD phones receive
OHVA, REJECT will appear at right-hand side of bottom line while this timer is activated.
OVERLAP INT DGT: Controls the grace period between receiving address information in overlap re-
ceiving mode via BRI/PRI line. After expiration of this timer the system operator will be alerted.
MMC 501 (Page 5 of 6)