Wiring Systems; Precautions - Suzuki Liana RH413 Service Manual

Wiring Systems

Body, Cab and Accessories
Cautions in Body Electrical System Servicing
When performing works related to electric systems, observe the cautions described in "Precautions for Electrical
Circuit Service in Section 00" for the purpose of protection of electrical parts and prevention of a fire from occurrence.
Precautions for Wiring System
WARNING
!
(For the vehicles with the Supplemental Restraint System (Air Bags) and/or the Seat Belt Pretensioner
System)
Service on or around the air bag system / Seat belt pretensioner system components or their wiring
must be performed only by an authorized SUZUKI dealer. Observe all the warnings of the "Air Bag
System" and disable the systems before performing the service. Failure to follow the Warnings could
result in unintended activation of the systems or could render the systems inoperative. Either of these
two conditions may result in severe injury.
CAUTION
!
To prevent damage to the electrical/ electronic parts (especially computers or semi-conductors) or to
prevent fire:
• When disconnecting the battery terminals, be sure to
1: turn off the ignition switch and all other switches,
2: disconnect the negative (–) terminal wire and then
3: disconnect the positive (+) terminal wire.
Connect the wires in the reverse order of disconnecting.
• When disconnecting the connectors, be sure to unlock the connector lock (if equipped) and then pull the connector
shells to detach them. Do not pull the wires.
• Connect the connectors by holding the connector shells. Make sure they are securely locked.
• Install the wiring harness securely without any slack.
• When installing parts, make sure the wiring harness is not interfered with or pinched by them.
• Avoid routing the wiring harness near or around a sharp corner or edge of the vehicle body or parts as much as
possible. If necessary, protect the wiring harness by winding tape or the like around on it.
• When replacing a fuse, make sure to use the specified capacity fuse. Using a fuse with a larger capacity can cause
damage to the electrical parts or a fire.
• Do not handle electrical/ electronic parts (computer, relay, etc.) roughly or drop them.
• Do not expose electrical/ electronic parts to high temperature (Approximately 80 °C (176 °F) or higher) or water.
• Be sure to insert the tester probe (or, if necessary, an appropriate needle or wire designed for the inspection work)
into the back side (wiring harness side) of the connector for inspection not to damage or deform the terminal of the
connector.

Precautions

Wiring Systems: 9A-1
S3RH0A9100001
S3RH0A9100002