Panasonic CF-07 Series Reference Manual page 18

CD-ROM Drive
Setting a Disc
Title-side up
Center Holder
Eject Button
<Only when the port replicator is connected>
1
Turn on your computer
2
Press the disc eject button and slowly pull out the tray
3
Place the disc securely on the center holder
4
Close the tray
CAUTION
Do not apply excessive force to the tray in the open position, doing so could
damage the tray.
Power-saving Mode
If the CD-ROM drive has not been accessed within 30 seconds, the drive motor will
automatically shut down to reduce the power consumption. When the CD-ROM drive is
accessed once again, the power of the drive motor is turned on. However, approxi-
mately 30 seconds are required until data is actually read from the disc.
NOTE
If the vibration of the CD-ROM drive is excessive, check to see if disc is inserted
correctly, and check that the disc is in good condition. If the disc is good and
inserted correctly, set [CD Drive Speed] to [Low] in the Setup Utility.
For AutoPlay CDs:
• If an AutoPlay CD does not start after the computer resumes from the standby
or hibernation modes, remove the disc from the drive, then reinsert the disc
again after a 15 second wait.
• An AutoPlay CD may start during file access, depending on the status of the
disc.
When playing back movies from a disc, note that smooth playback may not be
possible in some cases.
18