G:\Work\SONY\TV\847342S DMX-WL1T\0724\387708311DMX-
WL1\050OTH.fm
010COV.book Page 17 Thursday, July 24, 2008 2:04 PM
3
Slide down the receiver unit.
If the Wireless LINK LEVEL is low, the receiver
unit can also be attached on the top right side of
the rear TV panel. In this case, attach the receiver
unit by rotating 180 degrees.
Remove the receiver unit from the TV Mounting
bracket on the rear TV panel, remove the TV
Mounting bracket/Plastic Fasteners using a
Phillips Screwdriver, remove the screws holding
the adapter and rotate 180 degrees, then secure the
screws again, attach the TV Mounting bracket and
the receiver unit.
Remove the screws
Rotate 180 degrees
~
• If no Guide Pins or screw holes are found on the rear
TV panel, it is not designed to mount the receiver unit
to the TV.
In case of small TV, Wall-Mount bracket and the
receiver unit might be interfered. Use the receiver unit
horizontally stand-alone.
Place the Receiver Unit Stand-alone
Near the TV
If the Wireless LINK LEVEL is still low, place the
receiver unit horizontally near the TV.
Find good place for Wireless LINK LEVEL.
Plastic
Fastener
Guide Pin
masterpage:Right
Secure the screws
DMX-WL1
3-877-083-11(1)
17