PTP 250 User Guide
Chapter 6: Configuration and alignment
This chapter describes all configuration and alignment tasks that are performed when a
PTP 250 link is deployed.
Before proceeding with unit configuration and antenna alignment, observe the precautions
described in
Preparing for configuration and alignment
Configure the two units, one as 'Master' and the other as 'Slave' by performing the
following tasks:
•
Connecting to the unit
up and open the web interface.
•
Upgrading firmware version
firmware version is installed on the unit.
•
Using the installation wizard
wireless, date and email attributes of the unit.
When all equipment has been installed at both link ends, perform the following tasks:
•
Aligning antennas
antennas.
•
Connecting link to the network
and connect to the network.
•
Saving the system configuration
system configuration to file.
phn-2182_003v004 (Oct 2011)
on page
6-3
describes how to connect a PC to the unit, power it
on page
6-10
on page
6-13
on page
6-23
describes how to align integrated and connectorized
on page
on page
UNDER DEVELOPMENT
on page 6-2.
describes how to ensure that the latest
describes how to configure the LAN,
6-30
describes how to review link performance
6-35
describes when and how to save the
6-1