Editing The Dme Wipe Pattern - Sony DVS-9000 User Manual

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

For pattern numbers, see "DME Wipe Pattern List" (page 453).

Editing the DME Wipe Pattern

By pressing the [EDIT ENBL] button to switch the memory recall section to

editing mode as shown in the following illustration, you can edit the selected

DME wipe pattern with the following buttons.

To exit from the editing mode, press the [EDIT ENBL] button once more, or

press the [EXIT] button.

Note that the operation of the following buttons is the same as when editing a

wipe pattern.

• [EXIT] button

• [PTN LIMT], [LIMT SET] buttons

• [NORM], [NORM/REV], [REV] buttons

• [KNOB 1/2] button

For the method of operation of these buttons, see "Editing the Wipe Pattern"

Channel selection buttons

1ST CH (channel 1): Selects channel 1.

2ND CH (channel 2): Selects channel 2.

You can also select two channels by pressing the buttons simultaneously.

DME wipe pattern edge setting buttons

BDR (border): Applies a border to the DME wipe pattern.

SOFT BDR (soft border): Softens the applied border.

DME Wipe Pattern Operations in the Multifunction Flexi Pad Control Block